The F1200 / F800 Protection Circuitry
The F1200 / F800 Protection LED relay speaker connection circuitry is active
when the amp[[lifier is powered on or off. When the circuitry is active, and all
connected speakers are muted (provided with 0 volts DC), thus protecting them
and preventing any audible Othump� from occurring.
The following conditions will cause the Protection circuitry to activate:
Y Initial power-up:For approximately five seconds after initial power-up, the pro-
tection circuitry is activated and the speaker output is muted. If everything is
operating normally, you will hear an audible click at the conclusion of this brief
period, as the protection circuitry is deactivated and the F1200 / F800 begins
delivering signal to connected speakers (at which point youOll hear a click).
Y Overheating:A temperature sensing device in the F1200 / F800 will cause the
protection circuitry to be activated (and the Protection LED to go on) whenever
the operating temperature of the unit rises above a safe level. To guard against
this problem, make sure the F1200 / F800 receives adequate ventilation on all
sides and that both the front and rear panels are unobstructed.
Y Severe overcurrent conditions: This occurs whenever the signal being input to
the F1200 / F800 rises to a level above 20% THD (Total Harmonic Distortion).
Y Shorted speaker cables:This will occur if, due to faulty wiring, the hot and
ground signals being output by the F1200 / F800 short one another.
Y Output impedance drops below 2 ohms:This can occur if the F1200 / F800 is
connected to inappropriate speaker systems (see the OSetting Up and Using
Your F1200 / F800� section on page 7 in this manual for more information).
Y DC voltage detected at speaker output:The most likely cause of this is an inter-
nal failure.
For further assistance, contact your local Samson dealer. If purchased in the
United States, you can call Samson Technical Support (1-800-372-6766)
between 9 AM and 5 PM EST.
8 |
ACEC
